You will have to keep pressure against the U-strap to allow the nut to turn. If this setting causes the rockshaft to raise all of the way up, you will have to insert the socket/extension through the hole and depress the spring-loaded U-strap and unscrew the nut a little until the rockshaft drops down. Move the rockshaft lift lever almost to the back of the slot, stopping with the back of the lever to the point where there is an angle to the slot (approx. Like another poster said, securely tape a deep socket on a long extension. Use a flashlight to look through the hole and locate the nut with a U-strap around the nut. To make it, the load shaft selector is raised all of the way up. Only after this adjustment is made should the adjustment through the hole in the back of the differential housing be made. The Load shaft lever by your foot at the bottom of the hydraulic lever console must be in the bottom position to first adjust whether the rockshaft lifts to the highest position and lowers all of the way down. ![]() Posted 18:12 (#6556946 - in reply to #6556436) Subject: RE: 4430 3pt will not raise problem foundĬab mounts could be part of the problem, but a total adjustment of the rockshaft valve will also be needed if the cab mounts are replaced. That sounds like a painful bit of education. ![]() A word of caution when doing this procedure, tape the joints of the socket and extensions to prevent them from separating or falling off inside the diff case.ĭon't ask how I came across this little tidbit of information.
0 Comments
Leave a Reply. |